What people are saying - Write a review
We haven't found any reviews in the usual places.
Other editions - View all
ahead ammunition anchor arms attached battery bearing block boat bolt boom breech buoy called carry cartridge CHAPTER charge clear closed coil comes containing course crew dangerous davits deck direction duties electric engine eye splice falls feet Figure fire follows forward front gasoline given hand handle head heaving hoisted hold hook keep knot lead lift light loaded lock lower magazine MARK means mooring mount moving necessary never officer operation paint pass pistol pointer port position powder precautions projectile pull range ready rear receiver removed rifle ring rope rudder running safety sail secured ship ship's shows side sight single slack slide sound speed station steering stern stop strand surface swing taken Training trigger turn usually vessel watch wire
Page 67 - In obeying and construing these rules due regard shall be had to all dangers of navigation and collision, and to any special circumstances which may render a departure from the above rules necessary in order to avoid immediate danger.
Page 63 - That the following regulations for preventing collisions shall be followed by all vessels navigating all harbors, rivers, and inland waters of the United States, except the Great Lakes and their connecting and tributary waters as far east as Montreal and the Red River of the North and rivers emptying into the Gulf of Mexico and their tributaries, and are hereby declared special rules duly made by local authority: SEC.
Page 203 - ... insert the lug on the collar in the undercuts in the extractor by pushing the extractor to the rear until its tongue comes in contact with the rim on the face of the bolt (a slight pressure with the left thumb on the top of the rear part of the extractor assists in this operation) ; turn the extractor to the right until it is over the right lug ; take the bolt in the right hand and press the hook of the extractor against the butt plate or some rigid object, until the tongue on the extractor enters...
Page 204 - Insert the follower and magazine spring in the magazine, place the tenon on the front end of the floor plate in its recess in the magazine, then place the lug on the rear end of the floor plate in its...
Page 200 - The bolt can not be drawn fully back, and its front end projecting over the rear end of the upper cartridge holds it down in the magazine below the action of the bolt. The magazine mechanism then remains inoperative, and the arm can be used as a single loader, the cartridges in the magazine being held in reserve.
Page 199 - ... draw the bolt fully to the rear, insert the cartridges from a clip, or from the hand, and close the bolt. To charge the magazine from a clip, place either end of a loaded clip in its seat in the receiver and, with the thumb of the right hand, press the cartridges down into the magazine until the top cartridge is caught by the right edge of the receiver. The...
Page 204 - ... the safety lock can be turned to the vertical position with the right hand ; insert the firing pin in the bolt and screw up the sleeve (by turning it to the right) until the sleeve lock enters its notch on the bolt.
Page 23 - To take charge of this post and all Government property in view. 2. To walk my post in a military manner, keeping always on the alert and observing everything that takes place within sight or hearing. 3. To report all violations of orders I am instructed to enforce. 4. To repeat all calls from posts more distant from the guardhouse than my own. 5. To quit my post only when properly relieved.
Page 203 - Grasp with the left hand the rear of the bolt, handle up, and turn the extractor collar with the thumb and forefinger of the right hand until its lug is on a line with the safety lug on the bolt...
Page 136 - When painting overhead surfaces, the ceiling panels should, as far as possible, be laid off fore and aft, and the beams athwartship. Where panels contain a great many pipes running parallel with the beams it would be difficult to lay off the ceiling panel fore and aft. In such cases better results will be obtained by laying off parallel with the beams.